1. Turn the pump on at the
mains power.
2. Depress the ON/OFF
switch to the ON ( l ) position
3. To turn the pump off, depress the ON/OFF switch to the OFF (0)
position.
1 Use a moist cloth to wipe down the pump housing. Allow to dry
thoroughly before storing in a dry location that is protected from
bad weather conditions.
2 .Before storing the pump. It is recommended to drain the pump.
Turn the drain plug anti-clockwise and remove from the pump.
This will drain any excess water. Replace the drain plug by turning
clockwise
TRP-650
4.
OPERATING THE PUMP
5. MAINTENANCE & STORAGE
OPERATION
NOTE: When the pump is fully primed and air is ushed
out , the pump is ready to operate. The pump may take
several minutes to fully prime air from inside the pump
and inlet pipe or hose.
This pump must be used with a residual current device with
rated residual current of 30mA or less.
Make sure the pump is disconnected from electric power
supply before performing maintenance procedures.
Remove drain
plug & allow
water to drain
out
NOTE: Ensure the gate valve on your water tank is not left open as
this will allow water to drain from the water tank.
To Next Page
Loading...
