EasyManua.ls Logo

Ozito PSDW-780 - User Manual

Ozito PSDW-780
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DIRTY WATER
SUBMERSIBLE
PUMP
780W
INSTRUCTION MANUAL
SPECIFICATIONS
Motor: 780W
Max. Flow Rate: 15,700l/h
Max. Head 8m
Max. Immersion: 7m
Min. Suction Depth 50mm
Max Particle Size: Ø35mm
Water Temp.: 1°C - 35°C
Weight: 5.22kg
PSDW-780
WHAT’S IN THE BOX
Submersible Pump
Universal Adaptor
IN ORDER TO MAKE A CLAIM UNDER THIS
WARRANTY YOU MUST RETURN THE PRODUCT
TO YOUR NEAREST BUNNINGS WAREHOUSE WITH
YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO
RETURNING YOUR PRODUCT FOR WARRANTY
PLEASE TELEPHONE OUR CUSTOMER SERVICE
HELPLINE:
Australia 1800 069 486
New Zealand 0508 069 486
3 YEAR REPLACEMENT WARRANTY
Your product is guaranteed for a period of 36 months from the
original date of purchase and is intended for DIY (Do It Yourself)
use only. If a product is defective it will be replaced in accordance
with the terms of this warranty. Warranty excludes consumable
parts, for example: o-rings, bearing, seals, gaskets, universal
adaptors, L-shaped connector.
WARNING
The following actions will result in the warranty being void.
If the tool has been operated on a supply voltage other
than that specified on the tool.
If the tool shows signs of damage or defects caused
by or resulting from abuse, accidents or alterations.
Failure to perform maintenance as set out within the
instruction manual.
If the tool is disassembled or tampered with in any way.
WARRANTY
TO ENSURE A SPEEDY RESPONSE PLEASE
HAVE THE MODEL NUMBER AND DATE OF
PURCHASE AVAILABLE. A CUSTOMER SERVICE
REPRESENTATIVE WILL TAKE YOUR CALL
AND ANSWER ANY QUESTIONS YOU MAY
HAVE RELATING TO THE WARRANTY POLICY
OR PROCEDURE.
OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175.
The benefits provided under this warranty are in addition
to other rights and remedies which are available to you at law.
Our goods come with guarantees that cannot be excluded
at law. You are entitled to a replacement or refund for a major
failure and for compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
Generally you will be responsible for all costs associated with
a claim under this warranty, however, where you have suffered
any additional direct loss as a result of a defective product you
may be able to claim such expenses by contacting our customer
service helpline above.
ozito.com.au
L-Shape Connector
1015

Questions and Answers

  • D
    David KruegerAug 6, 2025
    What to do if my Ozito Water Pump does not start or pump water?
    • S
      Samantha SnyderAug 6, 2025
      If your Ozito Water Pump isn't starting or pumping water, first, ensure it's properly connected to the power supply. If connected, check that the float switch is activated by manually raising its position. Also, inspect the impeller for any obstructions and clean them if necessary. If the thermal overload protection has activated, wait for the motor to cool down. If none of these steps work, the motor may be damaged, consider contacting Ozito customer service.
  • K
    Karen MurrayAug 12, 2025
    What to do if Ozito PSDW-780 Water Pump motor is running but not pumping water?
    • J
      Julie HobbsAug 12, 2025
      If the Ozito Water Pump is running but not supplying water, start by cleaning the suction base of any foreign matter or debris. Next, try several start-ups to remove any air bubbles from the hose/tube and/or pump. Alternatively, lift and tilt the pump slightly while it's running to dislodge air. Also, check the discharge hose/tube for kinks, damage, or blockages, and un-kink or replace it as needed. Finally, disconnect the power and check the discharge outlet for any foreign matter.
  • M
    Michaela CurryAug 17, 2025
    Why is the flow rate of my Ozito PSDW-780 reduced?
    • A
      Alexandra LewisAug 17, 2025
      If the flow rate of your Ozito Water Pump is reduced, ensure you are not exceeding the maximum head/immersion rating. If exceeded, reduce below the maximum rating. Also, check the suction base for partial obstructions and clean it. Remove any obstructions in the hose/tube. Check the suction line connections for air leaks, and tighten or fix them. Finally, ensure the discharge lines are the correct length and assembly instructions are followed to prevent air and water leakage.
  • C
    Caitlyn MillerAug 23, 2025
    What to do if Ozito PSDW-780 Water Pump will not turn off?
    • B
      Becky SmithAug 23, 2025
      If your Ozito Water Pump won't turn off even when the water level is low, it's likely that the float switch is stuck in the 'on' position. Ensure that the float switch is free to operate normally. If the problem persists, contact Ozito customer service.
  • A
    amandareyesAug 29, 2025
    How to keep hose/tube on Ozito Water Pump universal adaptor?
    • L
      Lindsey FordAug 29, 2025
      If the hose/tube does not stay on the universal adapter of your Ozito Water Pump when water is flowing, it may be that the hose/tube is slightly wider than the adapter. You can use an adhesive inside the hose/tube, fix Teflon tape around the universal adapter, or use a hose clamp to secure it.

Summary

WARRANTY

3 YEAR REPLACEMENT WARRANTY

Details the 3-year replacement warranty terms and conditions.

KNOW YOUR PRODUCT

ACCESSORIES

Lists and identifies included accessories for the submersible pump.

SETUP & PREPARATION

UNIVERSAL ADAPTOR

Explains how to prepare and fit the universal adaptor for various pipe sizes.

OPERATION

L-SHAPE CONNECTOR

Details the steps for connecting the L-shape connector to the pump housing.

FLOAT SWITCH

Explains the function and operation of the float switch for pump control.

SETUP

OPERATE

INSTALLATION

TROUBLESHOOTING

SAFETY INFORMATION

Electrical Safety

Essential electrical precautions for safe operation and preventing hazards.

General Safety Warnings

Key safety guidelines to prevent injury and damage during use.

Pump Specific Safety

Additional safety instructions specific to pump operation and handling.

Ozito PSDW-780 Specifications

General IconGeneral
Power780W
Max Head8m
Outlet Size1 inch
Maximum Submersion Depth7m
Particle Size35mm
Voltage230-240V
Frequency50Hz
Cable Length10m

Related product manuals