Ozito PSDW-780 - KNOW YOUR PRODUCT; ACCESSORIES; SETUP & PREPARATION; UNIVERSAL ADAPTOR

ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1. Float Switch Cable
2. Float Switch Adjustor
3. Float Switch
4 Pump Housing
5 Suction Base
6 Outlet
7 Handle
SUBMERSIBLE PUMP
KNOW YOUR PRODUCT
1. UNIVERSAL ADAPTOR
Preparing the Universal Adaptor
The universal adaptor is designed to t various sizes of pipes and
ttings.
8. L-Shape Connector
9. Universal Adaptor
ACCESSORIES
SETUP & PREPARATION
Tota25mm(1’’)tapadaptor
(temporary application only)
1. Cut the universal adaptor using
a hack saw. Ensure all ashing is
removed.
2. It is now ready to be tted with a
25mm (1’’) screw on tap adaptor
(not included).
Tota32mm(1¼’’)
rigidpipeorexibletubing
(Temporary or permanent application)
. Cut the universal adaptor using
a hack saw. It is now ready to be
tted with a 32mm (1¼’’) rigid pipe
or exible tubing (not included).
Tota25mm(1’’)rigidpipeor
exibletubing
(temporary or permanent application)
. No cutting of the universal adaptor
is required. It is ready to be tted
with a 25mm (1’’) rigid pipe or
exible tubing (not included).
Ensure the pump is disconnected from the power supply
before performing any of the following operations.
NOTE: TO USE THE PUMP IN PERMANENT
INSTALLATIONS WITH RIGID PIPES, INSTALL A
NON-RETURN VALVE TO AVOID THE FLUID BEING
RE-CIRCULATED ONCE THE PUMP HAS STOPPED.