Chapter Three System Program
37
3.61 Flash Time
Format 1: * 83 ABCD #
ABCD = Flash time = 500ms to 2000ms
Description: FLASH here means user taps hook-switch fleetly, it is function is as lifts
handset rapidly after hangup. FLASH TIME is the time length between
hangup and re-lifts handset, if user does not lifts handset when flash time
is expires, system will regard it as hangup; if user is lifts handset within
assigned flash time, system will regard user is ready to transfer a call (2.7).
Example, the assigned FLASH TIME is 1200ms, user does not lifts handset
after 1200ms, system will regard it is hangup; when user lifts handset after
1200ms since hangup, system will regard user is ready to make a new call;
when user lifts handset within 1200ms since hangup, system will regard user
is ready to transfer a call.
Example: Assign flash time is 1000ms.
Operating: 1) Lifts extension 8001 and unlock;
2) Input * 83 1000 # ;
We are suggest assign flash time as 760ms normally.
3.62 Call Bill Memory Cleared
Format 1: * 96 00 #
Description: Call Bill Memory is use for store call bill when computer is closed, the
recorded bill will be transferred to computer when PC Bill Software is
running.
Normally, use this function to clear call bills created by system debugging.
1. The call bill can not be restored once it is cleared;
2. Allows store maximum about 2,500 pieces call bill when computer is
closed (the storage is related with length of number).
We are suggest upload bill to computer regularly, otherwise, memory
cannot store bill when it is full.
At factory default is Tone Mode.
3.63 Pulse and Tone Mode Setting
Format 1: * 28 M #
M = 0 = Tone mode
M = 1 = Pulse mode
Description: Allows assign Pulse or Tone mode for CO line.
To Next Page
Loading...
Need help?
General
