PAC Stinger ELEV8 - Page 5

Stinger ELEV8 or HEIGH10® Radio Replacement Kit
for Jeep Wrangler JL and Jeep Gladiator JT Vehicles
SRK-JW18EH
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not a󰀩liated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identication purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 5
Rev: v3
Date:100620
Part Four: Door Sill Trim Removal
Section 1: Disassembly (Cont.)
Step 2
Step 1
Use a plastic panel removal tool
to open the driver side handle
bolt covers, then remove the two
10mm bolts.
Use a plastic panel removal tool
to remove the panel on the driver
side of the dash.
Step 4
Step 3
Remove the two T25 screws on
the inner-most side of the driver
side upper door seal trim; then,
while pulling towards the middle
of the vehicle, use a plastic panel
removal tool to remove it.
Remove the two T25 screws on
the underside of the driver side
upper door seal trim.