operation. However, if the driver observes
low friction road conditions (such as snow,
rain, ice) and does not want the
transmission to shift, risking wheel
slippage, the driver should select Manual
Mode. Manual Mode holds the current gear
position under most operating conditions-
the transmission will only shift when the
driver makes an upshift or downshift
request. Once road conditions improve, the
driver should revert back to Drive Mode.
T
railer Operation
Trailer Connecting
• Prior to backing under the trailer,
ensure proper trailer height.
• Use Low mode (1
st
gear) for
forward direction and Reverse (R1)
for reverse direction.
Sliding Trailer Axle
• Ensure axle rails and locks are
properly maintained.
• Follow proper procedure for
unlocking and sliding the trailer
axles.
• Use Low mode (1
st
gear) for
forward direction and Reverse (R1)
for reverse direction.
•
Avoid repeat attempts if the sliding
axle is not moving.
NOTE
If repeat attempts are made and the au-
tomated clutch starts to overheat, the
display will indicate CA along with a
warning tone.
Vehicle Towing
When towing the vehicle, the output shaft
of the transmission must not be allowed to
spin or turn. If the vehicle is towed with the
drive wheels still in contact with the road
surface, the vehicle axle shafts or driveline
must be removed or disconnected.
CAUTION
Always follow proper manufacturer
towing procedures. Failure to follow
proper towing procedures could result
in damage to the transmission.
OPERATION - Trailer Operation
Y53-1349-1A1 (02/2022) 41
5
To Next Page
Loading...
