16
OPERATING INSTRUCTIONS
2. Press the On/Off switch (A) to
the ON (I) position.
Note: DO NOT start removing grout
at the joint (the intersection of four
tile corners). This may cause tile
damage, cracking, or the tile popping out.
3. Initially, run the tool at low speed,
applying minimal pressure to
remove grout. Increase speed
and pressure as required for
optimal performance.
Note: Applying too much pressure
will cause the tool to stop vibrating.
4. To turn the tool OFF, press the
on/off switch (A) to the
OFF (O) position.
4
A
2
A
1
3
2
To Next Page
Loading...