15
OPERATING INSTRUCTIONS
Stroke (SPEED) Adjustment
The stroke adjustment dial (B) on the side of the removal tool
housing controls the stroke length.
1. To adjust stroke length, turn dial
to desired speed.
• Low speed (1) is for ne
detail and the narrowest of
grout widths.
• Medium speed (2-3) is for
detail of trim pieces, quarter-
rounds, v-caps, liners, etc.
• High speed (4-5) is for working
on eld tile, counters, walls,
oors, etc.
Operating the Grout Remover
Note: ALWAYS wear safely glasses, a dust mask, and hearing
protection when using grout remover.
Note: Make sure that tip (F/G) is securely fastened.
1. Connect power cord (C). Hold
the tool at 45° angle.
1
B
2
1
1
C
45°
To Next Page
Loading...