3
Charging the Battery
Important! Before using the Frozen Scooter for the rst time the
battery needs to be charged for a full 10 hours. Only an adult who has
read and understands the following safety warnings should handle,
charge or recharge of the battery.
1. Remove the seat, as described on page 10.
2. Disconnect the red connectors.
3. Plug the charger connector into the red connector from the battery.
Only use the Kid Trax Toys charger included with the Scooter (Input:
AC 120V–, 0.2A, 60Hz Output: DC 7V, 0.8A).
4. Plug the charger into a standard 120V wall outlet.
Note: The charger may feel warm during charging. This is normal and
not a cause for concern.
5. After charging is complete (at least 8 hours, but no more than 10)
unplug the charger from the wall outlet.
6. Unplug the charger from the charging connector and connect the
battery connectors.
7. Place the seat back on the vehicle, and lock into place.
charger
battery
12
red battery
connector
To Next Page
