How to fix a PACOM PC868 that is not responding or automatically resets?
If your PACOM Thermometer is not responding or automatically resets, the batteries might be used up, in wrong polarity or type, or there might be poor battery contact. Try replacing the batteries with new ones, ensuring they are inserted with the correct polarity.
Why does my PACOM Thermometer show the symbol “Hi”?
If your PACOM Thermometer displays the symbol “Hi”, it could be due to a temperature hampered by an air flux. Please leave the status and wait for ?? minutes to measure, then re-measure according to the manual. In forehead measurement mode, it may be caused by temperature readings taken too close together or by measuring other objects like sunlight or air from a fireplace. In object measurement mode, it may be due to temperature readings taken too close together, or because the object temperature is higher than ????.
What to do if my PACOM PC868 shows the symbol “Lo”?
If your PACOM Thermometer displays the symbol “Lo”, it could be due to several reasons. The hair and sweat may prevent accurate temperature readings, or the temperature may be affected by an air flux. In forehead mode, the measuring distance might be too far, or the device may be picking up interference from other objects like air conditioners. In object mode, the measuring distance could also be too far, or water vapor might have condensed on the lens. If the ambient temperature is outside the range of (???-???), keep the thermometer in a room with a temperature within that range for ?? minutes. If the battery is low, replace it with a new one. If none of these issues are the cause, and you suspect sensor or hardware damage, rule out temperature allowance first, then send the device to yo...
Details the necessary preparation steps before operating the thermometer.
Provides guidance for initial setup, calibration, and first-time use of the thermometer.
Explains the step-by-step process for taking temperature measurements.
Step-by-step guide for taking temperature measurements, including distance and beep signals.
Detailed steps for taking measurements in surface temperature mode.
General| Brand | PACOM |
|---|---|
| Model | PC868 |
| Category | Thermometer |
| Language | English |
To Next Page
