PACSystems RX3i - Release History

RX3i Ethernet NIU 7
GFK-2419M
Release History
Catalog Number FW Revision Comments
IC695NIU001-DM 5.70 Enables support that is functionally identical to the IC695CMX128 for the
IC695RMX128.
IC695NIU001-CL 5.61 Corrects the problem described in GFK-2419L.
IC695NIU001-CL 5.60 Supports the IC695PMM335 PACMotion Multi-Axis Motion Controller and other
new features, and corrects the problems listed in GFK-2419L.
IC695NIU001-CK 5.50 Supports Run-mode store of EGD.
Adds support for LREAL data type.
IC695NIU001-CJ 5.03 Corrects problem of Corrupted User Memory issue after a power cycle.
Corrects problem in 5.02 firmware only, in which loss of certain IC694 and IC693
modules in an expansion rack caused the outputs of similar modules in expansion
racks to be disabled when the “Loss of Module” fault was configured as
diagnostic.
IC695NIU001-BH 5.02 Fixed an issue where certain IC694 and IC693 modules in the main rack did not
transition to stop mode after a “Loss of Module” fault was logged.
IC695NIU001-BG 5.00 Supports Proficy Process Systems rel. 1.00, Scan_Set_IO, Quality Function
Blocks, Optional UDF Parameters, IEC Transitionals, SNPT Network time sync.
IC695NIU001-BF 3.83 Support for PACSystems RX3i Serial Communications modules IC695CMM002
and CMM004.
IC695NIU001-BE 3.82
IC695NIU001-BD 3.81 Support for eight ETM modules in the main backplane.
IC695NIU001-AC 3.52
IC695NIU001-AB 3.51
IC695NIU001-AA 3.50 Initial Release
Important Product Information for this Release
This release enables support that is functionally identical to the IC695CMX128 for the IC695RMX128 on all Rx3i CPUs.
Updates
The IC695NIU001 is field upgradeable to firmware version 5.70 using the firmware upgrade utility. To upgrade an existing
NIU001 to firmware version 5.70, you will need the 44A753013-G12 upgrade kit, which can be downloaded from
http://support.gefanuc.com/.