What to do if my Pahlen Swimming Pool Heater heat pump will not start?
If your Pahlen Swimming Pool Heater's heat pump won't start, first check for a power failure and ensure the circuit is working and power is restored. Verify that the operating switch is turned on. Also, check the fuses and replace them if they have tripped. Finally, examine the display for any error codes, as a security device may have stopped the pump.
Why is my Pahlen Swimming Pool Heater running but not heating enough?
If your Pahlen Swimming Pool Heater is running but not providing enough heat, the air intake or outtake might be blocked. Check and clean them. Also, the evaporator could be blocked, so check the circuit. If a restart delay is active, simply wait it out.
What to do if Pahlen Calidi XP Swimming Pool Heater display is normal but there is no operation?
If your Pahlen Swimming Pool Heater display is normal but there is no operation, it could be that the set water temperature has been reached. Try setting a higher required temperature. Alternatively, a restart delay of 3 minutes might be in effect, so wait.
Safety features and operational indicators of the heat pump.
Full power and Eco modes for different heating needs.
Safe handling and movement procedures.
Bypass kits, ground, and wall stands for installation.
Recommended locations and clearance for optimal performance.
Essential checks before electrical hookup.
Schematic for electrical connections.
Connecting external relays for control.
Overview of the display, buttons, and settings.
Initial startup, temperature setting, and water flow adjustment.
Choosing operational modes (Full power/Eco).
Heat pump's automatic frost prevention.
Manual activation of defrost cycle.
Guide to connect heat pump via mobile app, covering download, registration, pairing, and troubleshooting.
General| Type | Electric Heater |
|---|---|
| Material | Stainless Steel |
| Heating element material | Incoloy 825 |
| Power | 3-18 kW |
| Connections | 50 mm |
| Temperature Range | 0-45°C |
| Voltage | 230/400 V |
| Maximum Flow Rate | 6.0 m³/h |
| Power Supply | Single or Three Phase |
To Next Page