WK-2x User Guide Version v1.2
The WK-2x can be configured in several modes: Access Point, WDS Root Access Point, WDS Repeater or
WDS Bridge. When shipped from the factory, the WK-2x is set to Access Point mode. The default IP
address of the WK-2x is 192.168.1.250 and username/password of pakedge/pakedgea.
In order to log in to the WK-2x, you must first configure the TCP/IP settings of your PC/Notebook. Follow
these steps:
1. Under Control Panel, double-click Network Connections and double-click the connection
of your Network Interface Card (NIC). The Local Area Connection Properties dialog appears:
2. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties. The Internet Protocol (TCP/IP)
dialog appears where you can configure the TCP/IP settings of your PC.
To Next Page
Loading...
