WK-2x User Guide Version v1.2
LAN
IP Network Setting: The default IP setting is DHCP. If this option is selected, the WK-2x will
automatically be assigned an IP address. Please make sure there is a DHCP server in your network
if you would like to use this option.
If you want to assign a static IP to the WK-2x, select Static IP from drop-down menu and fill in IP
address, subnet mask and gateway information. Click Apply to implement your changes.
Spanning Tree Protocol (STP)
Spanning Tree Protocol (STP) prevents bridge loops. By default, this feature is enabled.
Management VLAN
Warning: Do not enable this feature unless you need to tag the default VLAN on the access
point. If configured incorrectly, the access point will become inaccessible and will need to be reset to
factory default. VLAN tagging can only be set on a managed switch capable of using VLANs.
VLAN ID for Management: To turn on VLAN Management, check Enable under Management
VLAN.
In the VLAN ID textbox, enter the number of the VLAN you want to access the administrative
functions of the WK-2x through. For example, if VLAN3 is used for management, type in 3.
Click Apply to save your changes.
To Next Page
Loading...
