23
ENGLISH
4
Before every ignition, be sure that burning pot is completely empty and properly positioned in its seat.
To start the stove hold the
button for several seconds.
The ame icon will start ashing during the ignition stage until remaining on steady when the stove has started.
Automatic stove ignition: the stove comes with an automatic device that starts the pellet stove without using other
traditional re lighters.
Avoid lighting the ame manually if the stove’s automatic ignition system is not working correctly.
When the stove is started the rst time, unpleasant odours or smoke may be generated, caused by evaporation
or drying of certain materials used. This phenomenon will gradually disappear.
The room should be well ventilated when starting the stove the rst few times.
MODIFYING THE PARAMETERS
The stove operating parameters can be modied as described.
The values set will be retained until next modied, even when the stove is switched o or unplugged from the
power supply.
SWITCHING OFF
To switch the stove o hold the button for a few seconds; the ame icon will switch o.
To start the stove again it’s recommended to wait for the stove to cool down completely.
The stove should only be switched o following the procedure described above. Never switch the stove o by
unplugging it from the power supply.
OPERATION WITH ROOM THERMOSTAT
When the stove is controlled by an external thermostat (or timer thermostat) the installer must have set
Conguration 2. In this conguration the stove switches o when reaching the external thermostat setting.
The stove switches on again automatically when the temperature falls below the value set on the external
thermostat (circuit closed).
The stove can be switched on/o manually or in programmed mode.
The stove modulates output according to the room temperature read by the probe on the stove (that is, the stove
attempts to maintain the desired temperature while minimising fuel consumption).
The desired room temperature can be set in the temperature menu
.
To Next Page
Loading...
Need help?
General
