22
Display brightness when in standby mode can be set.
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press to conrm;
c) Use the button to scroll to and select submenu [11] and press to conrm;
d) Set the desired brightness (OFF, 1 ... 5) using the buttons and press to conrm.
The data shown on the display when this is in standby mode can be set.
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press to conrm;
c) Use the
button to scroll to and select submenu [12] and press to conrm;
d) Set one of the following values using the
and buttons:
• The display remains on the last operation set by the user;
• All operating parameters are displayed cyclically;
• The room probe temperature is shown
• The current time is shown
• The operating autonomy in hours before having to rell the hopper is shown, If the function
“lling” has been activated.
e) Press
to conrm the settings.
The volume of the buzzer can be set based on requirements:
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the
button to select the password “7” and then press to conrm;
c) Use the
button to scroll to and select submenu [13] and press to conrm;
d) Set the desired volume (OFF, 1 to 5) using the buttons and press to conrm.
A good combustion depends on several factors (type of installation, operation and maintenance conditions, type
of pellet etc ..)
If at the end of combustion in the brazier are many waste, it is advisable to change the combustion congurations
(increasing the value) to nd the most satisfactory solution.
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press to conrm;
c) Use the button to scroll to and select submenu [1 4 ] and press to conrm;
d) Set one of the following values using the and buttons:
e) Press
to conrm the settings.
To Next Page
Loading...
Need help?
General
