21
ENGLISH
3 PRELIMINARY
OPERATIONS
LOADING THE PELLETS
The rst operation to be performed before starting
the appliance is to ll the hopper with fuel (pellets).
The pellets are loaded into in the hopper using a
scoop.
Do not empty the sack directly into the hopper so
as to avoid loading sawdust or other foreign bodies
that may aect proper stove operation and avoid
spilling pellets outside of the hopper.
Make sure the hopper lid is well closed again after
having loaded the pellets. A safety switch (just for
the models that are equipped with it) makes sure
that the pellet tank lid has been closed properly (IS
in g. 3.1) and triggers a stove alarm in case the
pellet tank lid stays open for more than one minute
while the stove is still working.
POWER SUPPLY
Plug the stove into the mains power supply, move
the power switch at the rear of the stove to position
“I” (Fig. 3.2). If the connections are correct the
stove will emit a series of intermittent beeps, the
display will come on.
If not using the appliance for an extended period,
the switch at the rear of the stove should be moved
to position (O).
INITIAL SETTINGS
The language, current date and time need to be
set before using the stove.
To set the date:
a) Use the buttons to go to the setup menu and press ;
b) Use the button to select the password “7” and then press to conrm;
c) Use the button to scroll to and select submenu [3] and press to conrm;
d) The hour value will ash; set the value using the buttons and press ;
e) The minutes value will ash; set the value using the buttons and press ;
f) The day value will ash; set the value using the buttons and press ;
g) The month value will ash; set the value using the buttons and press ;
h) The year value will ash; set the value using the buttons and press ;
i) The current weekday value will ash (Monday = 1... Sunday = 7); set the value using the buttons;
j) Press to conrm the settings.
IS
To Next Page
Loading...
Need help?
General
