104
Opening the Platform
Press the pushbutton (43) on the hand cable control 1 and
hold it in this position. Briefly after this press and hold the
pushbutton (44) on the same hand cable control. Hold both
pushbuttons in this position until the platform is horizontal.
Note: When loading the platform, you can simply compensate for
any height differences by using the "open" or "close" func-
tions.
Setting the Safety Railing Upright
Grasp one of the safety railings lying on the platform and
swivel it up.
Secure the safety railing it its upright position. For this pur-
pose, engage the lug of the fastener to the hook.
Repeat these steps for the other safety railing.
Lifting the Platform
If required, open the top flap. This is necessary if you want
to use the upper vehicle deck.
Press either the pushbutton (42) on hand cable control 1 or
the pushbutton (45) on hand cable control 2 and hold it in
this position until the platform has reached the required
height.
Bringing Down the Platform
Press either the pushbutton (44) on hand cable control 1 or
the pushbutton (47) on hand cable control 2 and hold it in
this position until the platform has reached the required
height.
Folding Out the Link Bridge
Press the pushbutton (46) on the hand cable control 2 and
hold it in this position. Briefly after this press and hold the
pushbutton (47) on the same hand cable control. Hold both
pushbuttons in this position until the link bridge has reached
the required position.
Betriebsanleitung_Hubladebuehnen_EN.book Seite 104 Donnerstag, 15. August 2019 4:04 16
To Next Page
Loading...
Need help?
General
