Need help?Do you have a question about the Palfinger V Series and is the answer not in the manual?
General| Series | V Series |
|---|---|
| Power Source | Hydraulic |
| Control System | remote control |
| Mounting Type | Vehicle-mounted |
| Operating Temperature Range | -20°C to +50°C |
| Weight | Varies by model |
Provides general scope and vehicle suitability information for the manual.
Outlines the procedure for requesting and approving lift modifications.
Illustrates main lift components with numbered labels.
Details frame material assumptions, steel strips, and frame strength checks.
Instructions for unpacking the lift and verifying kit contents against the packing list.
Information on the availability of an optional work light from the manufacturer.
Lists essential checks for vehicle body, closure, frame strength, and clearances.
Details bracing requirements for box bodies based on lift capacity.
Explains fitting kits and necessary bracing for dropside bodies.
Details requirements for vehicles over 3.5 tons needing an under-run bar.
Provides instructions and diagrams for safely lifting the tail lift unit.
Guides on adjusting lift height, ground clearance, and vehicle centering.
Details tack welding the lift to the vehicle frame and component protection.
Specifies fillet weld size and technique for unpainted steel columns.
Covers installation compliance, positioning, height, and attachment methods for under-run bars.
Instructions for positioning and securing droppers to chassis and under-run bar.
Details installation of universal stays for the under-run bar device.
Specifies positioning of vehicle rear lights according to regulations.
Instruction to remove the transit strut between column tops.
Guidance on cutting columns and adjusting chain links for floor height.
Instructions for wiring the power pack with appropriate cable specifications.
Warning against attaching wiring to brake or hydraulic lines for support.
Guidance on checking lead specifications for chassis/body earth connections.
Details routing battery cables and connecting the main fuse assembly.
Instructions for selecting location and mounting the lift isolation switch.
Guidance on mounting the optional internal switch within the vehicle body.
Describes wiring external/internal switches and isolation switch to the power pack.
Step-by-step guide for filling the hydraulic system with oil.
Outlines the procedure for initial testing of the lift's operation.
Instructions for thorough lubrication of chains after painting.
To Next Page