To avoid the danger of fire, heat and electronic damage when welding,
disconnect the vehicle battery.
Always connect earthing lead directly to component being welded. Do not earth through
hydraulic hoses or pipework.
Protect the power pack, hoses, bearings and wiring from heat and weld splatter.
WELDING FRAME
Tack welds the lift to the vehicle rear frame.
The tack welds must be of adequate
strength to support the full weight of the lift.
Do not fully weld the columns prior to
lowering the runners to the ground or
damage to the rear wear pads will result
If the lift is galvanised or fully painted, then
clamp to rear frame. Do not weld. Ensure
clamps are adequate to support the full
weight of the lift.
To Next Page
Loading...
Need help?
General
