Need help?Do you have a question about the Palfinger V 500 LQ and is the answer not in the manual?
General| Brand | Palfinger |
|---|---|
| Model | V 500 LQ |
| Category | Lifting Systems |
| Language | English |
General precautions to be taken before working with heavy duty springs, highlighting potential dangers.
Warning regarding welding near plastic runner slide pads and specific areas to avoid.
Safety precautions for welding, including battery disconnection, earthing, and protection from splatter.
Procedure for tack welding the lift to the rear frame and considerations for not fully welding columns prematurely.
Instructions for applying 5mm fillet welds of 100mm length to columns for unpainted steel vehicle frames.
Procedure for bolting the lift frame to the vehicle, including screw types, drilling, and torque settings.
Details on fixing screws without nuts, tapping threads, and preparing threads with Loctite.
Installer's responsibility to ensure the under-run bar complies with regulations.
Installer's responsibility to ensure vehicle lights comply with regulations after tail lift fitting.
Minimum cable specifications for power pack connections, detailing models, power, voltage, and cable size.
Guidelines for extending and routing power pack cables, avoiding damage and sharp edges.
Procedure for wiring earth return (single pole) and ensuring adequate lead capacity for chassis/body earth.
Instructions for fitting the main fuse assembly, routing battery cables, and protecting the fuse.
Warning that the link to the battery should only be connected when all wiring installation is complete.
Steps for filling the hydraulic system with oil, ensuring the correct level is reached in the power pack.
To Next Page