28
To switch on the tail lift using the key code at the lateral oper-
ating element:
Enter the key code using the Lift and Close pushbuttons
(see “Programming a Key Code” from p. 125).
The operational readiness of the tail lift is shown by an op-
tical signal in the driver's cab.
To switch on the tail lift using the battery main switch:
Turn the battery main switch clockwise until the cam is en-
gaged.
The operational readiness of the tail lift is shown by an op-
tical signal in the driver's cab.
Betriebsanleitung_Hubladebuehnen_EN.book Seite 28 Donnerstag, 15. August 2019 4:04 16
To Next Page
Loading...
Need help?
General
