Why is my Pall Laboratory Equipment system not filling or draining properly?
The fluid supply to your Pall Laboratory Equipment might be restricted or closed. Check the fluid supply, ensuring that all clamps on the appropriate line are open and the tubing isn't pinched or twisted. Also, make sure all connections on the appropriate line are fully activated.
What to do if the Allegro biocontainer system does not open correctly during fill in Pall Laboratory Equipment?
The Allegro biocontainer might not open correctly during filling because it was unfolded prior to installation. These systems are designed to self-unfold and self-position, so ensure the side panels are folded over the top face of the system when installed. Another reason might be that the Allegro system is installed with the folded sections at the front and back of the tote instead of at the sides. Reinstall the system, checking that the corners of the biocontainer are aligned with each of the tote's corners.
What to do if there are excessive creasing and folds during filling of Pall Laboratory Equipment system?
Excessive creasing and folds during filling may occur if the selected system is too large for the tote being used. Make sure the correct single-use system is selected and properly installed in the chosen tote.
What to do if the Pall Laboratory Equipment system does not form to the sides of the system?
If the system doesn't form to the sides, it might be because the selected system is too small for the tote being used. Double-check that the correct single-use system is selected and properly installed in the chosen tote.
How to fix Pall Laboratory Equipment if the system does not align with the corners of the tote?
If the locating port bracket is securely in position, yet the system doesn't align with the tote's corners, it might be due to the locating port bracket being installed in reverse. Confirm that a Pall Allegro biocontainer system is being used. If so, align the port bracket as shown in Figure 34. If you're using another manufacturer’s biocontainer, reverse the bracket as per Figure 35.
Details the preparation steps for Allegro plastic totes and their accessories, including trolley and tote preparation.
Guides on inspecting, preparing, and installing Allegro 3D biocontainer systems into Allegro plastic totes.
Detailed instructions for installing a 100 L or 200 L biocontainer system into the 200 L Allegro plastic tote.
Steps for installing a 500 L biocontainer system into the 500 L Allegro plastic tote, including front access door removal.
Provides warnings and instructions for filling Allegro 3D biocontainer systems, including outlet line closure and filling commencement.
Covers procedures for dispensing fluid from the Allegro tote system, including bottom and top dispensing methods.
General| Diameter | 50 mm |
|---|---|
| Material | PTFE |
| Product Type | Filter |
| Pore Size | 0.2 μm |
| Application | Liquid and Gas Filtration |
To Next Page
