Why is my Pall Laboratory Equipment system not filling or draining properly?
The fluid supply to your Pall Laboratory Equipment might be restricted or closed. Check the fluid supply, ensuring that all clamps on the appropriate line are open and the tubing isn't pinched or twisted. Also, make sure all connections on the appropriate line are fully activated.
What to do if the Allegro biocontainer system does not open correctly during fill in Pall Laboratory Equipment?
The Allegro biocontainer might not open correctly during filling because it was unfolded prior to installation. These systems are designed to self-unfold and self-position, so ensure the side panels are folded over the top face of the system when installed. Another reason might be that the Allegro system is installed with the folded sections at the front and back of the tote instead of at the sides. Reinstall the system, checking that the corners of the biocontainer are aligned with each of the tote's corners.
What to do if there are excessive creasing and folds during filling of Pall Laboratory Equipment system?
Excessive creasing and folds during filling may occur if the selected system is too large for the tote being used. Make sure the correct single-use system is selected and properly installed in the chosen tote.
What to do if the Pall Laboratory Equipment system does not form to the sides of the system?
If the system doesn't form to the sides, it might be because the selected system is too small for the tote being used. Double-check that the correct single-use system is selected and properly installed in the chosen tote.
How to fix Pall Laboratory Equipment if the system does not align with the corners of the tote?
If the locating port bracket is securely in position, yet the system doesn't align with the tote's corners, it might be due to the locating port bracket being installed in reverse. Confirm that a Pall Allegro biocontainer system is being used. If so, align the port bracket as shown in Figure 34. If you're using another manufacturer’s biocontainer, reverse the bracket as per Figure 35.
Procedures for receiving Allegro 200 L and 500 L plastic totes, trolleys, and lids.
Guidelines for receiving Allegro 3D single-use biocontainer systems sterilized by gamma irradiation.
Steps for preparing Allegro plastic totes and accessories for use, including trolley brakes.
Comprehensive guide for preparing, installing, and using Allegro biocontainer systems in plastic totes.
Detailed steps for installing a 100 L or 200 L biocontainer system into the 200 L Allegro tote.
Detailed steps for installing a 500 L biocontainer system into the 500 L Allegro tote.
Guidance on using single-use systems from other manufacturers with Allegro plastic totes.
Procedures for filling Allegro 3D biocontainer systems, including warnings and notes on port usage.
Explains the primary uses of Allegro plastic tote lids for protection during storage and movement.
Safe practices for moving filled Allegro totes, with or without trolleys, emphasizing slow movements.
Procedures for dispensing fluid from the Allegro tote system, covering bottom and top port methods.
Step-by-step instructions for safely removing a biocontainer system from the Allegro tote.
General| Brand | Pall |
|---|---|
| Model | Allegro 500 L |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
