Palm Centro - Page 32

33
Mac only: Double-click the CD icon on the desktop, and then double-click
the PalmSoftware.pkg icon.
5. Select the same language you selected on your Centro, and then select
Install HotSync
®
and Palm Desktop software.
6. When the install program asks you to sync, connect the USB sync cable to a
USB port on your computer and to the USB connector on the bottom of your
Centro.
7. Press the sync button on your cable.
Messages on both your computer and your Centro indicate that
synchronization is in progress. Do not disconnect the sync cable until you see
the message on your Centro saying that the HotSync
®
operation is done.
Next time you want to sync, just connect your Centro to your computer (using
the sync cable) and then press the sync button.
Tip
Problems
synchronizing? See
"Synchronization
isn't working" on
page 39 for
troubleshooting
suggestions.
Sync button
Sync cable