CUSTOMIZING YOUR SMARTPHONE
CONNECTION SETTINGS
203
9
CHAPTER
8 Select the 802.1x tab, and then set the
following if available (the settings vary
based on your settings on the other
tabs and on the supported features of
your Wi-Fi SDIO card):
Use IEEE 802.1x network access
control: Lets you set these parameters
if required by the network.
EAP type: Specifies the extensible
authentication protocol type.
9 Press OK .
Selecting a Wi-Fi network
After you set up a Wi-Fi connection, it’s
easy to connect to that network. If you
have access to multiple Wi-Fi networks,
you can select which network you want to
connect to.
1 Wake up your smartphone’s screen (see
Waking up the screen and turning it off
),
and then insert the Wi-Fi card into the
expansion slot (see Removing and
inserting expansion cards).
2 Tap Wi-Fi in the title bar.
3 Select the Settings link.
4 Select Network Cards .
5 Highlight the network you want to
connect to.
6 Press and hold Center to open the
shortcut menu, and then select
Connect.
TIP
Insert the Wi-Fi card into your smartphone
to automatically connect to the Wi-Fi network
you connected to most recently if it is
available.
DID
YOU
KNOW
?
When you are browsing the
Internet or performing another Wi-Fi activity,
you can answer a call without interrupting that
activity.
To Next Page
Loading...
