Pamex FKL - Setup Mode; Change Programming Code

28
SETUP MODE
IMPORTANT :
The internal thumbturn enables / disables exterior lever.
The internal thumbturn is horizontal posion to be unlocked (passage lock).
The internal thumbturn is vercal posion to be auto-locked (entry lock).
Please DO NOT press the lever when programming the lockset
1.CHANGE PROGRAMMING CODE ( THIS PROGRAMMING CODE MUST BE 6-DIGITS IN LENGTH)
(1) The pre-set programming code of the product is 123456, please change it before operang
the lockset.
(2) Keep a wrien copy of programming code in a safe place.
(3) Programming code can be used to unlock.
Procedures:
(1) Rotate the internal thumbturn to horizontal posion → press # ( the red indicator is on, you
are in
setup mode )
(2) Enter 1-2-3-4-5-6 (or current Programming Code) → press# → press10 → press# → input new
programming code → press # ( the red indicator is off in 10 sceonds ).