5
Fold here
Place on door edge
51 45 40 35
Drill 1''(25mm) hole
at center of door edge
2''
1-3/4''
1-9/16''
1-3/8''
O54mm(2-1/8'')
Backset 70mm(2-3/4'')
Backset 60mm(2-3/8'')
1. Remove lever lock, or do not install lever lock prior to painting your door.
2. Do not let any water or liquid into the lockset during installation process.
TEMPLATE
IMPORTANT BEFORE PROCEEDING
NOTE:MEASUREMENTS BELOW ARE JUST A GUIDELINE. Please measure your door to determine
the exact center of your door edge.
To Next Page
Loading...