Pamex FKL - Disable Button Sound (Mute Mode); Setting Auto-Lock Time Delay; Restore Factory Setting

31
6.DISABLE BUTTON SOUND (MUTE MODE)
Procedures
(1) Rotate the internal thumbturn to horizontal position press # (the red indicator is on, you
are in setup mode)
(2) Input programming code press# press 60 press#.
(Please repeat the above procedures to enable the button sound)
7. SETTING AUTO-LOCK TIME DELAY
Procedures
(1) Rotate the internal thumbturn to horizontal position press # (the red indicator is on, you
are in setup mode)
(2) Input programming code press# press 70 press# press the seconds for
(5-90) press# (the red indicator is off in 10 seconds).
8.RESTORED FACTORY SETTING
Procedures
Rotate internal thumbturn to horizontal position remove any of the batteries press and
hold # until all batteries are installed again reset is finished when a long
beep of 3 seconds and a short beep.
(Such action will delete all the stored , will be reset to the
default
(DEFAULT VALUE IS 5 SECONDS)
delay time
of auto-locking
the lock beeps
user codes the programming code
code 123456. Please re-change the programming code for the safety purpose.
NOTE: Do not enter leading zeros - use''5'' not''05''.
6.DISABLE BUTTON SOUND (MUTE MODE)
7. SETTING AUTO-LOCK TIME DELAY
8.RESTORED FACTORY SETTING
SETUP MODE