Panasonic AG-1980P - Tuning TV Channels to VCR

Tuning
the
TV channels
to
your
VCR
Antenna
POWER
audio signals
in the VCR to a standard
broadcast
signal that
your
TV
can receive.
The RF converter can
transmit this
signal
on
channel 3 or 4.
To
prevent
any
interference it
is advisable
that
you
select
the channel that is
not normally broadcast in your
area.
Tuning procedure
3
O
CH3
CH4
1
Refer to pages 5
and
6,
and
confirm
that the
VCR
and
TV have been
connected
correctly.
2
Turn on the
VCR and TV.
3 Set RF
Converter Channel
Selector (on
the
rear
panel)
to
''CHS" or
“CH4'’;
whichever
is
not normally broadcast
or
the least
viewed.
This
is to
select a
channel for
video
playback.
Channel
Reception Check
1
Set channel 3
or 4 on your
TV
(selected
in
step
3)
in
order
to
check a
proper broadcast
reception.
2
Press VCR/TV (on
the
front panel) to
“VCR” to
select
the
“VCR”
operation mode.
•The “VCR” indicator
appears on the
VCR Display.
3
Select channels
on
the
VCR that
you
would
normally
receive clearly
in
your area to check
proper
reception.