Device: Panasonic AG-CX350 and AG-CX10
Introduction
The Device Core “Panasonic CX350” is used for controlling the AG-CX350 and AG-CX10 cameras. The
goal of this manual is to help configuring a SKAARHOJ interface to control features available in the Device
Core at this present time.
Multicam Control
Please note with the release of UniSketch v2.4.16 Multicam Control have been enabled. Prior to v2.4.16
only a single camera could be controlled from the Device Core. With the update up to 4 cameras can be
controlled from a single Device Core. Please see information in the section “Multicam Control”
Known Problems
Update April 2021
We are aware of trouble with Iris control when using the CX-350 camera firmware above v4.0. We have
reached out to Panasonic to try to resolve the issue. If possible please use CX-350 camera firmware 2.01,
as we do not have the issue with that version. You can also contact support@skaarhoj.com for a temporary
work around on the newer CX-350 firmwares.
Update June 2021
With the introduction of CX-350 firmware version 6.01 the Iris issue has been resolved, however there is a
problem with disconnect. It is best to continue with CX-350 camera firmware 2.01.
To Next Page
