Setting up Camera
In order to control the camera it must be connected to the same network as your SKAARHOJ Controller..
All communication between a SKAARHOJ interface and the camera is done via IP. The implementation
have been done on version 1.01-00.0.00
A number of actions are required for a SKAARHOJ controller to communicate with the camera. Please
follow these procedures in the MENU —> NETWORK SETTINGS. The aim of the procedures is to set a
static IP address on the camera which the SKAARHOJ controller can connect to and to create a user
account for authentication. You can use a different IP address as long as the Panasonic Device Core on the
SKAARHOJ controller reflects this.
•
MENU - NETWORK - DEVICE SEL - LAN
To Next Page
Loading...
