Panasonic AG-HMC41EJ - RECORD SETUP Screen

103
RECORD SETUP screen
Item
Display
mode
Q.MENU Description of settings
REC FORMAT CAMERA
Selects the recording format.
PH 1080/50i
PH 1080/25P
PH 720/50P
PH 720/25P
HA 1080/50i
HG 1080/50i
HE 1080/50i
You cannot change the format during interval recording.•
PREREC
MODE
CAMERA
Sets PRE RECORDING to ON or OFF. (Page 47)
ON OFF
TCG is set to FREE RUN.
Cannot be set during INTERVAL REC.
•
•
TIME STAMP CAMERA
Specifies whether date and time information is superimposed over
recorded images.
ON: Superimposes date and time information on the image.
OFF: Does not superimpose date and time information on the
image.
INTERVAL REC CAMERA
Enables frame-by-frame recording at specified intervals to create short
videos of scenes with slow movement over long periods of time. Single
frames are recorded at the specified interval, with 24 frames equaling 1
second of video.
OFF, 1 SECOND, 10 SECONDS, 30 SECONDS, 1 MINUTE,
2MINUTES
When INTERVAL REC is enabled, the following setting items
automatically change as follows.
REC FORMAT: PH 1080/25P
•
TCG CAMERA
Sets the mode in which you advance the internal time code generator.
FREE RUN: The time code is advanced regardless of the operation
mode.
A slight time error may occur when switching to PB mode if the frame
rate is set to 25P.
REC RUN: The time code is advanced only when recording.
TC PRESET CAMERA
Sets the initial time code.
YES NO
Set the frame value to 0 or a multiple of 4 when you set recording
frame rate of recording format to 25P. If any other value is set, the
recorded time code will mis-match.
•
UB PRESET CAMERA
Sets the user information.
YES NO
WIND CUT CAMERA
Reduces noise caused by strong wind blowing against the built-in mic.
ON OFF
When an external mic or an XLR Microphone Adapter is connected,
this setting is fixed at OFF.
•
MIC ALC CAMERA
Sets mic level auto control to ON or OFF (CH1 and CH2
simultaneously).
ON OFF
Set to ON to reduce distortion at high input levels. To adjust the
recording level of audio signals (not related to this setting), adjust the
mic settings in the Function Navi.
•
: Can also be configured in Quick Menu. (Page 97) indicates the factory setting.
USO RESTRITO