Panasonic AG-HMC41EJ - Power Sources; Using the Battery; Using the AC Adaptor

24
Power sources
Using the battery
Installation
Insert the battery until it clicks into place.
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the battery while pressing the
battery release button.
Support the battery with your hand to ensure
that it will not fall.
Mode lampBattery release button
•
Using the AC adaptor
Installation
1
Connect the DC cable to the AC adaptor.
2
Plug the AC power supply cable into the
power outlet.
3
Insert the DC cable’s battery connector until
it clicks into place.
DC cable’s battery
connector
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the DC cable’s battery connector
while pressing the battery release button.
3
Disconnect the AC power supply cable from
the power outlet.
CAUTION:
When the AC power supply cable is
disconnected from the power outlet, the power
lamp on the AC adaptor remains lit for a while
then shuts off. This is not a malfunction.
•
•
USO RESTRITO