119
Updating the firmware
For the latest information on firmware updates, visit the support page at the following Web site.
http://pro-av.panasonic.net/
Cleaning
When cleaning, do not use benzene or thinner.
Using benzine or paint thinners may deform the camera-recorder and/or cause the surface finish to peel
off.
Before proceeding with maintenance, remove the battery or disconnect the AC cable from the power
outlet.
Use a soft, clean cloth to wipe the camera-recorder. To remove stubborn dirt, wipe the camera-recorder
with a cloth moistened with kitchen detergent that has been diluted with water and then use a dry cloth to
take up the remaining moisture.
Cleaning the eye piece
When the outer lens becomes dirty
After removing the surface dust with a soft brush or blower brush, wipe the
lens with a commercially-available lens cleaner (and lens cleaning paper).
When dust becomes attached to the inner filter, the inside of the eye
piece or the LCD monitor within the viewfinder.
Remove the eye piece and remove the dust.
Remove the surface dust with a soft brush or blower brush.
Do not use solvents such as thinner to remove dust or dirt.•
•
•
•
■
■
Eye cup
Projection
Eye cup
holder
Eye cup
Projection
Eye cup
holder
To Next Page
Loading...
