29
VV
TT
RR
12
Detailed description of set-up menus
TAPE PROTECT
Item Setting
Description of setting
No. Item No. Item
400 STILL 0000 0.5s
TIMER 0001 5s
0002 10s
0003 20s
0004 30s
™™
0005 40s
0006 50s
0007 1min
0008 2min
401 SRC 0000 STEP
PROTECT 0001 HALF
™™
402 DRUM STDBY 0000 OFF
0001 ON ™™
403 STOP 0000 STEP
PROTECT 0001 HALF
™™
The underlined number and item are the factory settings.
DETAILED DESCRIPTION OF SET-UP MENUS
This selects the time taken before the tape protection mode is established
when the laptop has been left standing in the stop or search STILL
(JOG/VAR/SHTL) mode.
(Units: s: seconds min: minutes)
<Note>
In the case of the DV format, the time will remain at 10 seconds even if a
value higher than 10 seconds has been selected. However, operation will last
for up to 2 minutes on the selection screen.
This selects the operation in the tape protection mode when the laptop has
been left standing in the STILL mode.
0: STEP (STEP FWD in STILL mode)
1: Half loading
<Note>
When STEP FWD has been selected, operation is automatically transferred
to half loading after the laptop has been left standing in the STILL mode for a
total of 30 minutes with the DVCPRO format or for a total of 1 minute with the
DV format.
This selects whether the drum is to be stopped in the standby OFF mode.
0: The drum is stopped.
1: The drum keeps rotating.
This selects the tape protection mode when the unit is left standing in the stop
mode.
0: Step FWD
1: Half-loading
<Note>
When step FWD has been selected, the mode will be automatically trans-
ferred to half-loading when the unit has been left standing in the stop mode
for a total of 30 minutes (or 1 minute for a DV tape).
To Next Page
Loading...
