Weight and dimensions shown are approximate.
Specifications are subject to change without notice.
DIGITAL
Sampling frequency:
Quantization:
Frequency response:
Dynamic range:
Distortion rate:
Crosstalk:
Wow & flutter:
Headroom:
Emphasis:
48 kHz
16 bits
20 Hz~20 kHz±1dB
More than 85dB (1kHz, emphasis off, “A” weighted)
Less than 0.1% (1kHz, emphasis off, standard level)
Less than –80dB (1kHz, between 2 channels)
Under measurable value
20dB
T1=50µsec/T2=15µsec (on/off enable)
ANALOG IN/OUT
Analog input (VTR1):
Analog input (VTR2, CH1):
Analog input (VTR2, CH2):
Analog output (VTR1):
Analog output (VTR2):
XLR×2 (CH1, CH2), high impedance, 4/0/–20dBu
XLR, high impedance, 4/0/–20dBu
XLR, high impedance, 4/0/–20/–50dBu
XLR×2 (CH1, CH2), low impedance, 4/0/–20dBu
XLR×2 (CH1, CH2), low impedance, 4/0/–20dBu
MONITOR OUTPUT/HEADPHONES
Monitor output (VTR1):
Monitor output (VTR2):
Headphones:
XLR×1, low impedance, 0dBu, CH1/MIX/CH2 selectable
XLR×1, low impedance, 0dBu, CH1/MIX/CH2 selectable
Mini-Stereo, variable level (Max. –20dBu), 8 ohms,
VTR1/MIX/VTR2 selectable, CH1/MIX/CH2 selectable
TC input:
TC output:
Remote:
EDL:
BNC ×1 (switched to reference input connector through OUT position)
BNC ×2 (switched to VTR1, VTR2, video monitor output connector)
D-sub 9-pin (female) × 2 (VTR1, VTR2), RS-422A interface
D-sub 9-pin (male), RS-232C interface
LCD display:
Brightness adjustment:
Screen adjustment:
Backlight switches:
6.5 inches TFT active matrix×2 (VTR1, VTR2)
Variable volume×2 (VTR1, VTR2)
Color, Tint, Contrast (separate left and right OSD menu)
Bright/Dark/Off (separate left and right switches)
Built-in speakers×2, VTR1/MIX/VTR2 selectable,
CH1/MIX/CH2 selectable
Counter:
Audio level meters:
Others:
8 digits (CTL/TC/UB selectable, total, remaining tape length)
16 steps
Servo lock lamp, DV lamp, tape travel status indication, recording/
recording inhibit lamp, DF lamp, Video/REF input lamp
To Next Page
Loading...
