EasyManua.ls Logo

Panasonic AQUAREA WH-ADC0912K6E5AN - Page 19

Panasonic AQUAREA WH-ADC0912K6E5AN
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
Item Unit Indoor Unit
Pressure Vessel
Material En-1.4521
Volume L 185
Design Pressure Bar 10
Heat Exchanger
Material EN-1.4521
Diameter mm 22
Thickness mm 0.8
Surface Area m
2
1.8
Total Length m 25
DHW Tank
Total Corrosion ion
(Chloride + Sulphate
+ Nitric)
mg/L < 150
Conductivity @ Water
Tank
Water Temperature
< 60ºC
µS/cm < 1250
Conductivity @ Water
Tank
Water Temperature
< 65ºC
µS/cm < 1200
Saturation Index (LSI)
@ 20ºC
> -4.0 / < 0.4
PH 6.0 - 8.5
Note:
Cooling capacities are based on outdoor air temperature of 35°C Dry Bulb with controlled indoor water inlet
temperature of 12°C and water outlet temperature of 7°C.
Heating capacities are based on outdoor air temperature of 7°C Dry Bulb (44.6°F Dry Bulb), 6°C Wet Bulb
(42.8°F Wet Bulb) with controlled indoor water inlet temperature of 30°C and water outlet temperature of 35°C.
Specifications are subjected to change without prior notice for further improvement.
* Above 55°C, only possible with backup heater operation.
** Between outdoor ambient -10°C and -15°C, the water outlet temperature gradually decreases from 60°C to
55°C.
It is recommended to follow DHW tank water quality limit for Panasonic Air to Water All in One according to
Drinking Water Directive 98/83 EC
In case it is necessary to indicate the air flow volume in (l/s), the value in (m
3
/min.) shall be multiplied by 16.7 and
rounded down the decimal point.
If the EUROVENT Certified models can be operated under the “extra-low” temperature condition, -7°C DB and
-8°C WB temperature with rated voltage 230V shall be used.
Flowrate indicated are based on nominal capacity adjustment of leaving water temperature (LWT) 35°C and
ΔT=5°C.
The sound pressure level is measured with distance 1.0m from the unit and height at 1.5m. (Test carry out for
cooling at ambient 35°C DB and Water Out 7°C, heating at ambient 7°C DB / 6°C WB and water out 55°C)
The sound power level is measured with accordance to EN12102 under full load conditions. (Test carry out for
cooling at ambient 35°C DB and Water Out 7°C, heating at ambient 7°C DB / 6°C WB and water out 55°C)
The sound power level is measured with accordance to EN12102 under conditions of the EN14825.
EER and COP classification is at 230V only in occordance with EU directive 2003/32/EC.

Table of Contents

Related product manuals