Panasonic CF-28 - Specifications; Setup Utility

8
Supplementary Instructions
Specifications “OPERATING INSTRUCTIONS ”
LAN IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
Wireless LAN IEEE 802.11b compliant
Frequency 2.4GHz band
Add the following information.
CardBus Controller B*
1
Disable
Enable
LAN (Only for models with LAN port) Disable
Enable
Boot up from LAN*
2
Disable
Enable
Wake up from LAN*
3
Disable
Enable
Setup Utility “REFERENCE MANUAL”
Replace the “Advanced Menu” for the following.
Parameters
( : Default)
Device Configuration: [BIOS]
Serial Port A: [Auto]
Serial Port B: [Disable]
IrDA Port: [Auto]
MP Serial Port : [Disable]
Parallel Port: [Auto]
Mode: [ECP]
Sound Controller: [Enable]
CardBus Controller A: [Enable]
CardBus Controller B: [Enable]
Modem: [Enable]
LAN: [Enable]
Boot up from LAN: [Disable]
Wake up from LAN: [Disable]
*
1
In [CardBus Controller B], set the Wireless LAN to enable/disable.
*
2
This function may not be displayed depending on model.
[Disable] is automatically set when [LAN] is set to [Disable].
*
3
[Disable] is automatically set when [LAN] is set to [Disable].
Wake up function works on Windows 98 or Windows 2000 irrespective of the [Wake up from LAN]
setting.
When the [Wake up from LAN] has been enabled;
In the OFF state, if you are not recharging your battery pack or if the pack is fully charged, your computer
consumes approximately 3.0 W.