106
Troubleshooting (Advanced)
A peripheral device does not work. z Install the driver.
z Contact the manufacturer of the device.
z When operation resumes from sleep
*5
or hibernation, devices such as a
mouse, modem and cards may not function properly. In this case, restart the
computer or reinitialize the device.
z When or is displayed in the Device Manager, remove and insert the
device. If the problem persists, restart the computer.
z When you set [USB Port] to [Disabled] in the [Advanced] menu of the Setup
Utility (Î page 83), USB ports of port replicator are also disabled.
z The computer may not recognize the connection/removal of some devices, or
may not operate normally with some devices.
A
Click (Start) - [Computer] - [System properties] - [Device Manager].
Click [start] - [Control Panel] - [Performance and Maintenance] -
[System] - [Hardware] - [Device Manager].
B
Select the device, and remove the check mark for [Allow the computer
to turn off this device to save power] in [Power Management]. (This
item may be unavailable for some types of devices.)
z In the case that a USB device does not work, remove the USB device and con-
nect it again or connect the USB device to another port.
The connected mouse does not work. z Check the mouse connection.
z Install the driver compatible with the connected mouse.
If the mouse does not work even after installing the driver, set [Touch Pad] to
[Disabled] in the [Main] menu of the Setup Utility (Î page 81).
USB floppy disk drive does not work
as a boot drive.
z The operation is confirmed by Panasonic CF-VFDU03U USB floppy disk drive
(optional).
z Connect the floppy disk drive directly to a USB port of the computer. Do not
connect it via a USB hub or USB connector of the port replicator. If you have
connected to a USB port on the computer, try connecting it to one of the other
USB ports.
z Set [USB Port] and [Legacy USB Support] to [Enabled] in the [Advanced] menu
of the Setup Utility (Î page 83).
z Set [Boot Option #1] to [USB Floppy Disk] in the [Boot] menu of the Setup Utility
(Î page 84).
z Turn off the computer and connect the USB floppy disk drive, and then restart
the computer.
Connecting Peripherals
To Next Page
Loading...
