Panasonic CF-52 Series - Page 66

66
LAN
Enabling the Power On by LAN function
The computer automatically turns from off to on when the computer is accessed from the network server via the internal LAN port.
1 Select [Allow] in [Power On by LAN] in the [Advanced] menu of the Setup Utility
(Î page 82).
2 In [Caution], press Enter .
3 Press F10 , and then select [Yes] and press Enter .
4 Log on to Windows as an administrator.
5
Click (Start) - [Computer] - [System properties] - [Device Manager].
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] -
[Device Manager].
6 Double-click [Network adapters] - [Intel(R) 82577LM Gigabit Network Connection], and
then click [Advanced].
7 Click [Enable PME] in [Property] and select [Enabled] in [Value], and then click [OK].
NOTE
z The computer may accidentally turn on if the linkage status is changed. To prevent the accidental startup, make the
setting by the following steps.
A
Click (Start) - [Computer] - [System properties] - [Device Manager].
z A standard user needs to enter an administrator password.
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager] -
[Network adapters].
B Double-click [Network adapters] - [Intel(R) 82577LM Gigabit Network Connection], and click [Advanced].
C
Click [Wake on Magic Packet] in [Property] and select [Enabled] in [Value], and then click [OK].
Click [Wake on Settings] in [Property] and select [Wake on Magic Packet] in [Value], and click [OK].
z If you forcibly shut down Windows, the Power On by LAN function will not work.