Panasonic CQ-C8400 - Preparation; Clock Setting

10
CQ-C8400/8300/8200/8100U
E
N
G
L
I
S
H
CQ-C8400/8300/8200/8100U
11
E
N
G
L
I
S
H
Preparation
1
2
3
Battery Installation
1 Remove the battery holder.
Pull the holder out at position B while pushing
position A as indicated.
2 Install the battery on the battery holder.
3 Insert the battery holder back into its original
position.
Battery Notes
≥ Battery type: Panasonic lithium battery (CR2025)
(included)
≥ Battery life: Approximately 6 months under
normal use (at room temperature)
≥ Remove and dispose of an old battery
immediately.
≥ Do not disassemble or short the battery. Do not
throw a battery into a fi re.
≥ Keep the battery away from children to avoid the
risk of accidents.
≥ Follow local regulations when disposing of the
battery.
Back side
Lithium battery
(included)
Battery holder
Position A
Position B
Remote Control Unit
Caution:
≥ Improper use of the battery may cause
overheating, an explosion or ignition, resulting
in injury or a fi re.
Subwoofer
Preparation:
≥ Connect the subwoofer (option) (page 70).
Subwoofer level setting:
≥ You can change the subwoofer level (page 44).
Subwoofer low pass fi lter setting:
≥ You can select the upper limit frequency of the
sound from subwoofer (page 44).
The 12-hour system is used for the clock.
≥ Turn your car’s ignition key to the ACC or ON
position.
≥ Press [SOURCE] (PWR).
≥ When the power is switched on for the fi rst
time, a demonstration appears on the display.
Press [DISP] (display) to change to regular
mode (page 22).
1 Press [MENU].
Press and hold [MENU] for more than
2 seconds.
2 Press [%] or [$] to select “DISPLAY”.
3 Press ["] or [#] to select “CLOCK ADJ”.
4 Press [SET].
5 Setting.
Hours:
1 Press [%].
The hour display hilights.
2 Press ["]: Put Forward
3 Press [#]: Put back
Minutes:
1 Press [$].
The Minutes display hilights.
2 Press ["]: Put Forward
3 Press [#]: Put back
6 Complete.
Press [SET].
Clock Setting