Panasonic CQ-DP975 - Page 11

MONO/LOCAL Selection
* Much interference is reduced during a weak FM stereo broadcasts
when MONO is ON. (Only for FM mode) >
* Searching stops automatically at a strong signal station only when
LOCAL is ON.
Press MONO to switch between stereo and MONO mode as follows.
MONO OFF ~t—» MONO ON
Press LOCAL to switch on or off the LOC mode as follows. `
LOCAL OFF «tp LOCAL ON
on cro0-r-ozm
Preset Station Setting
Up to 24 stations can be preset in the station memory as follows;
me [ re | A
[Gstaions | 6 stations | stations | 6 stations
Manual Station Preset
(D Press BAND to select adesired band.
@ Use manual or seek tuning to find a station that you want to
program into memory.
(3) Press and hold one of the station selector buttons 1 through 6 for
more than 2 seconds until the display blinks.
Repeat the process to set other stations for the FM1 to AM bands.
"3EM3 ID 15
P-3
Note: You can change the memory setting by repeating the
above procedure.
Tuning in a Preset Station
Press any of the buttons 1 through 6 to tune in the station preset by
the above steps @ to ©.
Auto Station Preset
Select a band, press APM.
* The 6 strongest available stations will be automatically set in
memory on preset buttons 1 through 6.
* Once set, the preset stations are sequentially scanned for 5
seconds each.
* Press the appropriate preset button for the station you want to
hear.
Caution: For safety reasons, do not attempt to program while driving.
11
CQ-DP975/DFX85EUC