Panasonic CQ-DP975

Remote Control Unit Basics
Battery Replacement (Remote Control Unit)
1.Remove the battery holder.
Pull the holder by the Position B while pushing Position A in the
direction indicated by the arrow. @Lithium battery
Rear view of remote
2.Replace the battery. control
Set a new battery properly with the (+) side up as illustrated.
3. Insert the battery holder. )
Push in the holder to the full. Position B
Notes on Batteries A
Old batteries must immediately be removed and disposed. Battery holder Position A
Battery Information:
* Designated Battery: Panasonic Lithium Battery (CR2025)
* Battery Life: 6 months with normal use (in normal room temperature)
Caution:
improper use of batteries may cause overheating, explosion or ignition, resulting in injury or fire.
Battery leakage may cause damage to the unit.
* Do not disassemble or short the batteries. Do not throw the batteries into the fire.
* To avoid the risk of accident, keep the batteries out of reach of children.
® Power Button
@BAND/DISC UP Button
@ATT Button
@TUNE/TRACK Button
® Volume Control Button
& Mode Button
Please refer Battery Replacement before using
remote control.
O
pe
rati
n
g
p
ro
ced
ures
m
aren
controller
toward
the
sensor
of
Attenuator
@ATT {ATT Button)
* Press ATT to immediately decrease
volume to about 1/10 of its previous level.
* Press ATT again to cancel.
Power
O POWER (Power Button)
Press POWER to switch on the power.
Press POWER again to switch off the power.
Mode Selection
6 MODE (Mode Button)
Press MODE to switch the operation
mode in the following order.
Radio — CD Player —> [UD “hanger
Control
ES
Volume
@VVOLA (Volume Control Button)
Press "^" or ^v" to increase or decrease
volume level.
1
: CQ-DP975/DFX85EUC