Panasonic CQ-DP975

Power and Sound Controls continued
Attenuator
* Press ATT to decrease volume to about 1/10 of the previous level.
e Press ATT again to cancel.
Changing Audio Modes
Press SEL to switch the audio mode in the following order.
Normal Mode * vO ME - BASS = TREBLE - SANE
L.——————— SUB-N e FADER +
Bass and Treble
* Press SEL to select the BASS (TREBLE) mode. Press "VOL^" or
"V VOL" to increase or decrease the bass (treble) response.
JAS+ dd TRE- 3d3
| |
-12 to +12 -12 to +12
4 * Press "VOL^" or “v VOL” for more than a half second to change
numeric levels on the display rapidly.
Balance
* Press SEL to select the BALANCE mode. Press "VOL^" or
"v VOL" to shift the sound volume to the right or left speakers.
1 to 15 1 to 15
Balance Center
* Press “VOLA” or ^v VOL" for more than a half second to change
numeric levels on the display rapidly.
Fader
* Press SEL to select the FADER mode. Press “VOLA” or ^" VOL"
to shift the sound volume to the front or rear speakers.
1 to 15 Fader Center 1to 15
* Press “VOLA” or ^v VOL" for more than a half second to change
numeric levels on the display rapidly.
Note: When an Audio control mode (BAS/TRE/BAL/FAD/SUB) is selected but no operation is made
within 5 seconds(2 seconds at VOL mode), the display will return to the normal operation mode. In
such a case, press SEL again to select the control mode.
8
CO-DP975/DFX85EUC