Panasonic CQ-HX2083U

E
N
G
L
I
S
H
24
CQ-HX2083U
51
E
N
G
L
I
S
H
23
CQ-HX2083U
50
Audio Settings [AUDIO]
Bass and Treble
You can adjust the bass and treble sound.
Default: BAS (Bass) 0 dB
TRE (Treble) 0 dB
Setting range: j12 dB to i12 dB (by 2 dB)
Balance and Fader
You can adjust the sound balance among
the front, rear, right and left speakers.
Default: BAL (Balance) CNT (Center)
FAD (Fader) CNT (Center)
Setting range: 15 levels each
Subwoofer setting
(LEVEL)
You can change the subwoofer volume level.
Default: 0 dB
Setting range: j∞ (subwoofer mute),
j6 dB to i6 dB (by 2 dB)
(FRQ: Frequency)
Select the upper limit frequency of the
sound from subwoofer.
Default: 120 Hz
Setting range: 120 Hz/80 Hz
S
·
HDB (Super High Definition Bass)
With music genres like rock music, the
bass-sound will be more powerful.
Default: S
·
HDB OFF
Setting range: S
·
HDB OFF, TIGHT, BOOM
2 1
Direct Operation
S
E
T
PWR BAND
FACE S
•
A
DISP DIM
MENU RET
123
44555666
77888
00
99
## MUTEMUTEMUTE
SCANSCAN
DIMMER
RANDOMRANDOMRANDOM
NUMBERNUMBERNUMBER
REPEATREPEAT
RETURNSOURCE
VOLVOL
Car AudioCar Audio
[ ]
In the case of remote control, as an alternative to
performing operations from the menu, the opera-
tions can be performed directly using the buttons
shown below.
12 3
2
Submenu 3 Set1 Menu
Press. Press.
(Example: S
.
HDB) (Example: BOOM)
Press. Press.
For details on how to perform menu operations
using the remote control, refer to page 28.
Note:
≥ Press [MENU] or [DISP] (display) on the remote
control to return to the regular mode.
≥ Press /[RET] (RETURN) to return to the pre-
vious display.
: The bass sounds of
the speakers are
strongly emphasized.
: The bass sounds of
the speakers are mod-
erately emphasized.
: S·HDB is non-active.
: Enhanced
: Decrease
:
Front enhanced
: Rear enhanced
: Right enhanced
:
Left enhanced
:Up
: Down
: No more than 80 Hz
: No more than 120 Hz
Subwoofer level
Subwoofer frequency
The following transition will be made by each [ ]
pressing.
Bass/Treble setting display
Balance/Fader setting display
Sub-woofer setting display
The following transition will be made by each [ ]
pressing and holding for more than 2 seconds.
(page 33)
Note:
≥ The same operations as the [ ] operations de-
scribed above can also be performed using
on the main unit.
BOOM indicator
lights.
TIGHT indicator
lights.