Panasonic CQ-RX100L

Radio (AM/FM)
[SRC] (Source) --------_
selects a source.
_- [TUNE ~] [TUNE ~]
down/up the frequency. (Hold it down for more than 0.5 seconds
and release it for seek tuning.)
[DISP] (Display) ------
switches the information on the
display.
[BAND] --------
selects a band in the radio source.
[APM] (Auto Preset Memory)
executes APM in the radio source. (Hold it
down for more than 2 seconds.)
Preset buttons [1] to [6]
selects a preset station in the radio source,
and presets the current station. (Hold it down for more than
2 seconds.)
:c
o
-
u.
=
o
:;::
ca
...
CD
CI.
o
1 Press [SRC] to select the radio source.
2 Press [BAND] to select a band.
_ .. _ .. _ .. -
t I
3 Select a station.
Frequency Adjustment
[TUNE ~]: Lower
[TUNE ~]: Higher
Note: Hold down for 0.5 sec. or more and release for
station search.
Preset Station Selection
Press the corresponding preset button from
[1] to [6] to tune
in a preset station.
lights while receiving an FM stereo signal.
Clock display
I~ '"'' I •. 11 .• 11 .. 1 ' :
, I I. LIL'_'
Display Change
Press [DISP] to change the display.
Radio mode display
(Default)
Preset Number
Frequency Band
Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively.
Preset stations can be simply called up by pressing [1] to [6].
I~ 1"/: = 1- -11- -I '--I ' :
-
CD
U)
1!
Q.
=
o
.-
-
ca
-
(I)
Auto Preset Memory (APM)
With this operation, stations with good receiving conditions
can be automatically stored in the preset memory.
1Select a band.
2Hold down [BAND] (APM) for more than
2 seconds.
The preset stations under best receiving conditions are received
for 5 seconds each after presetting the stations (SCAN). To stop
scanning, press one of the buttons from [1] to [6].
Manual Station Preset
1Tune into a station.
2 Hold down one of the preset buttons from
[1] to [6] for more than 2 seconds.
(blinks once)
Note: New stations overwrite existing saved stations.
Note: New stations overwrite existing saved stations.