Panasonic CQ-RX100L

Audio Settings
[VOL] -------------_
selects a value in the audio menu.
(PUSH SEL) (Push to select)
selects items in the audio menu.
[DISP] (Display)
exits from the audio menu.
1 Press [VOL] (PUSH SEL) to open the audio menu.
Note: If no operation takes place for more than 5 seconds in audio setting (2 seconds in the volume adjustment,
10 seconds in the SQ adjustment), the display returns to the regular mode.
2 Press [VOL] (PUSH SEL) to select a
mode to be adjusted.
3Turn [VOL] clockwise or counterclockwise to
adjust.
"",-. ,-,,,
...L"- -'.:..:.' -. - L'L' ...L'
It' I IL II- -I
F 1- -I :I F 1'- -,
:-11- -IL L 1'- -,
,-"", ,f-
,- -, L"--' !..... -. - u
.",-. ,- '"
• ,- \ L -.- L"- -'...L'
CD: Up
@:Down
CD/@: center frequency up/down
[ !+II] [~]: Band selection
[/\] [v]: Level up/down
CD: Increased
@: Decreased
CD: Right enhanced
@: Left enhanced
CD: Increased
@: Decreased
CD: Front enhanced
@: Rear enhanced
=
=
II)
:i
c;)
.-
"CI
='
<
Notes:
• The volume can also be adjusted directly using [VOL] on the main unit. ( .... "General")
• For further information on SQ (Sound Quality) settings, refer to "Sound Control".
• Do not activate SQ and BassfTreble at the same time to avoid causing sound distortion.
1II"i'!ltluil 1II'liE!1nnil
• The sequence and contents of setting items may depend on the conditions of devices to be connected. For further information,
refer to the System Upgrade Guidebook or the instruction manuals for the devices to be connected.
lII.j;£t4eItlil 'ij.jifjuulll 'lI'IiOuInl
• If the fader is set to front, the pre-amp. output (rear) is decreased.