10
5 Disassembly and Assembly Instructions
5.1. How to Remove the Flexible PCB
Front Panel
Front Panel
FFC (CNP3)
Connector
Cover
Plate
4. Disconnect the FPC Ass'y from CN452 on the TFT
PCB (E-9939A)
.
CN452
FPC Ass'y
CN707
Front Panel
Slide Mechanism
Ass'y
(Monitor Ass'y)
Monitor
Disassembly of Display Unit
. Remove the two screws( ) from the Front Panel.
2. After removing the screw ( ) from the bottom side, remove
the Connector Cover.
3. Disconnect the FFC (CNP3), which is connected to
the Front Panel, from CN707 on the Main PCB (E-3173Aa).
1. Pull out the Monitor to the arrow direction.
2. After removing the two screws ( ) and one screw ( ),
remove the Plate.
3. After removing the four screws ( ), remove the Monitor Ass'y.
4.Remove the Front Panel.
Front Panel
Monitor
To Next Page
Loading...
