EasyManua.ls Logo

Panasonic CR-SM4208U - Bluetooth Configuration; Setting Bluetooth PIN Code; Bluetooth Connection Management

Panasonic CR-SM4208U
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
Notes:
We shall not guarantee all the functions of the
Bluetooth
®
device to be connected. When opera-
tions cannot be performed via this unit, operate
the system via the Bluetooth
®
device.
Be aware that the battery of a Bluetooth
®
device
drains faster if the Bluetooth
®
device is con-
nected to this unit.
Even when the Bluetooth
®
device that is con-
nected to this unit is located near this unit,
sound may be interrupted or noise may be
generated.
The Bluetooth
®
device with over 5-digit PIN code
is not operated with this unit.
“B/T DISCOND is displayed when the Bluetooth
®
device is disconnected.
Setting of PIN (Personal Identity Number) code
1
Hold down [6] for more than 2 seconds
to call the PIN code entry mode.
2
Press [6] to prepare for adjustment.
1st digit blinks
3
Enter a number for each digit.
[!!!!!!!!] / [!!!!!!!!] : Selects number (0 9).
[6] : Selects next digit to be entered.
Digit entered
4
Press [6] to determine the PIN code
entry when last digit is entered.
Completed
Note: To check the Bluetooth
®
address of this head
unit, press [SEL] after step 1.
Connection of the registered
Bluetooth
®
device to this unit
1
First,select the matching Preset No.
Bluetooth
®
device of interest. (Refer to
the above.)
2
Press [PHONE] and then press [SEL] to
connection.
!
The Bluetooth
®
indicator ( ) lights.
Notes:
Even if [SRC] (Source) is pressed to change the
source, the connection stays connected.
Depending on the communication status, it may
takes 5 to 40 seconds for device connection.
Disconnection of the Bluetooth
®
device
Press [PHONE] 後再按下 [SEL]確定斷線.
The Bluetooth
®
indicator ( ) turns off.
Note: When the Bluetooth
®
device is out of reception
range or encounter serious interference by outer
signal, “ERROR” appears and this unit will automati-
cally disconnect the connections.
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
]
/
/
/
/
/
/
/
/
/
/
/
/
/
Cmvfuppui
¯
!.!Hfofsbm!)dpoujovfe*!

Related product manuals